Obsidian Wire Custom 4-Way für Tele, 250k Pots

99,00 € *

inkl. MwSt. zzgl. Versandkosten

Sofort versandfertig, Lieferzeit ca. 1-3 Werktage

  • TM-60128
Achtung. Bitte unbedingt die Original Fender Controlplate verwenden. Alle anderen passen von... mehr

Achtung. Bitte unbedingt die Original Fender Controlplate verwenden. Alle anderen passen von den Lochabständen her leider nicht. Die passenden Knöpfe und Kontrollplatte findet ihr unter Zubehör weiter unten auf der Seite.

Note: Aftermarket control plates will not fit. We recommend a genuine Fender control plate. You will find the controlplate and knobs if you scrolldown.

All ObsidianWire Pro-Wired Electronics are super easy to install, and allow for solder-less pickup changes with ObsidianWire Plug, Play & Enjoy connectors. Make Your Tele® Scream.

The ObsidianWire Custom 4-Way wiring harness for Telecaster® adds a tasty fourth switch position to make your Tele scream.
NOTE: Requires Three Wire - Neck Pickup Mod * See Below

Kick your Tele into the fourth position and your old work horse becomes a beast. The neck and bridge pickups work in series to provide a more powerful humbucker like tone. You can use this position for stronger rhythm and screaming leads. Your Telecaster will retain all of the traditional switch positions, and the familiar master tone and volume controls.

The 4- Way Telecaster Switch Goes Like This
1: Neck & Bridge Pickup in Series (Humbucker Like Tone
2: Neck Pickup Only
3: Neck & Bridge Pickup in Parallel (Traditional Tele)
4: Bridge Pickup Only

Crystal Clear Tone

To make your tone crystal clear at lower volumes we also include an ObsidianWire Custom Spec Treble Bleed Mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.

World’s Best Craftsmanship and Components

  • ObsidianWire Custom Select Pots (Crafted by CTS) (+/-8%) (Matched to +/-2%) SOLID SHAFT
  • Genuine Oak Grigsby Switch
  • Genuine Switchcraft Output Jack
  • ObsidianWire Custom Select 150 Series Polyester Film Capacitor (Hand Tested to +/-10%)
  • ObsidianWire Premium Selected Volume Mod / Treble Bleed - Improved Volume Taper & Clarity

Compatibility

  • American and Mexican series Fender® Telecasters - Direct Fit
  • Japanese Fender & Squiers - You will need to purchase a genuine Fender USA control plate and new 1/4" knobs to fit the higher grade electronics.
  • Other Guitars - We cannot guarantee that these will fit any other guitar.

Note: Aftermarket control plates will not fit. We recommend a genuine Fender control plate – Part Number: 099-2058-000

At ObsidianWire we use US spec 1/4" Solid shaft controls. We recommend that you check your knobs are the correct size and replace them if necessary.

Three Wire Neck Pickup Mod

- To properly ground your neck pickup you will need to add an additional wire to it. This is an easy mod & we provide the instructions and wire to do the job but it does require a solder joint. Please allow for this when buying this upgrade.

Bewertungen lesen, schreiben und diskutieren... mehr
Kundenbewertungen für "Obsidian Wire Custom 4-Way für Tele, 250k Pots"
Bewertung schreiben
Bewertungen werden nach Überprüfung freigeschaltet.

Die mit einem * markierten Felder sind Pflichtfelder.

Auf Lager
GOTOH Tele Bridge, Messing Reiter GOTOH Tele Bridge, Messing Reiter
49,00 € * 69,00 € *
Auf Lager
Eis Spray, Nitro Relic Eis Spray, Nitro Relic
Inhalt 400 Milliliter (22,50 € * / 1000 Milliliter)
9,00 € *
Auf Lager
Nitro Zellulose Schnellschleifgrund - klar, Gitarre, Spraydose 400ml Nitro Zellulose Schnellschleifgrund - klar,...
Inhalt 0.4 Liter (37,25 € * / 1 Liter)
14,90 € *
Auf Lager
Nitrolack Heritage Cherry, Spraydose oder Gebinde 250ml Gebinde Nitrolack Heritage Cherry, Spraydose oder...
Inhalt 0.4 Liter (47,50 € * / 1 Liter)
ab 19,00 € *
Auf Lager
Pro Shield, Abschirmlack Pro Shield, Abschirmlack
Inhalt 50 Milliliter (318,00 € * / 1000 Milliliter)
15,90 € *
Zuletzt angesehen